Quick and Easy to Install!
(video coming soon!)
1. First you need to find your OBD-II interface.
This is the diagnostics port located usually under the
dash, on the drivers side.
2. Turn the ignition switch to “ON”
3. Plug the KVW100 to OBD-II interface.
Always be sure that the module has been plugged in properly, and pushed in as far as possible to ensure a good contact.
4. The KVW100 will give a long beep.
The update time is less than 1 minute.
Once completed, the KVW100 will give 3
short beeps, congratulations! Your car has been updated successfully. It has
the function of auto closing windows!
5. pull the KVW100 out from OBD-II interface.
Please note: Do not throw the KVW 100 away, even though this is a one time use device, you will need it in the event you wish to add new remotes in the future to you car, while maintaining the auto roll up function.
Important: If the KVW 100 gives off a series of beeps initially then the update is not successful, please remove it and begin again.